Home > Gaming > Overclocking > Phase-Change Basics 2: Setting Up a System

Phase-Change Basics 2: Setting Up a System

As the compressor has been exposed to the atmosphere for quite some time
already, the oil inside might be contaminated so I decided to pour out the oil
and put in some fresh mineral oil. It is easier to pour out the oil through the
discharge line, bringing the compressor upside down to drain off the oil.

You will need to shake it now and then and let the oil slowly trickle out.
This will take some time and you can do it between intervals. After this, take
note of the amount of oil drained out and put back the same amount. I put the
fresh oil back through the suction line. Only put the oil back in when you are
ready to braze up the whole system.

VR-Zone is a leading online technology news publication reporting on bleeding edge trends in PC and mobile gadgets, with in-depth reviews and commentaries.

Leave a Reply

Your email address will not be published.

Read previous post:
Phase-Change Basics 1: Using the Tools

This is the first part of the guide to phase-change cooling that covers the refrigeration tools and how to use...